V10 changes (dimensions in mm)
- Main monitor-floor thickness: 5 -> 7; mounting holes remain 7 through / 12 x 4 counterbores.
- Rear stop screw holes remain plain 7 mm through, no rear posts.
- Keyboard main plate thickness: 7 -> 8; 7 mm through-holes at both main mounts (formerly 5.3).
- Main mount sockets now OPEN AT TOP; tongue can be lowered into slot rather than threaded into closed tunnel.
- Both wing connectors: TOP-OPEN step pockets with 0.55 mm XY clearance and 0.7 mm height allowance. 7 mm vertical through-bolt holes on wings and center.
- Full-thickness land is preserved under all four wing mounting pockets.
- Beware: raised wing tongues need slicer overhang/support checking (all sockets are open for removal/cleanup).
- Test fit with an isolated connector sample before large prints; verify actual monitor-foot geometry and safe monitor load.
- M6 bolts, large washers and locknuts recommended; no bolt heads are recessed at the connections.
